Five important safety notes when using breast pump
Don’t get a used pump.
Although it saves cost considerably when sharing or borrowing a friend’s breast pump, or buying one used, the FDA and breastfeeding experts generally caution against it. Breast milk may pass bacteria and infections that can contaminate these pumps and pass a disease to mothers and children. Also, since beads of drain can infiltrate the interior parts, using an own collection kit are not safe to use any longer. Additionally, used pumps may not be as powerful in light of the fact that engines lose their quality and the seals exacerbate after some time, issues that may prompt lost suction.
Pumps designed for multiple users, like hospital grade pumps, are intended to keep breast milk from getting inside the pump. For whatever length of time that users utilize one with their private collection unit, they’re protected.
When using only one side of a double pump, seal the other side.
Not doing so reduces the pump’s suction and makes it less efficient.
Pay attention to breast shields and choose the right-size one.
Breast shields are a standout amongst the most critical breast pump highlights. Breast shields, also called flanges, are the cups that mothers put on their breasts. Legitimate breast shields will fit in mom nipples’ size, not the size of mom’s breasts.
For a too tight breast shield, moms contribute to damage their nipples which were at that point sore. Therefore, moms regularly pick going up a size over what’s furnished with the pump. However, the too enormous one could cause matter for mother’s discomfort as well since the breast, not just the nipple, will be sucked in. That can mess with the stream of breast milk. Breastfeeding can be sufficiently troublesome without mother’s drain supply decreasing.
Clean pump parts after utilization.
All breast pump parts that interact with breast milk, for example bottles, valves and flanges, ought to be cleaned after each utilization. Users don’t have to sanitize them, simply wash with dish cleanser and warm water; at that point flush with high temp water for 10 to 15 seconds and permit to air dry on a perfect paper towel (Should check pump’s manual for particular guidelines previously utilizing).
Don’t clean the tubing unless breast milk gets into it.
Users may see small water drops in the tubing after pumping. If that occurs, just turn the pump back on for a few minutes to dry the tubes out. If still seeing milk in the tubing, users should check the manual for cleaning instructions and let it air dry before reattaching to the breast pump.